Diy Ribbon Wreath Hanger. Yarn wreath yarn + laced ribbon + pins + burlap + fabric In fact, you just outline a wooden monogram piece with pine cones, and then hang with a pretty ribbon.
Use the 6″ ribbon that was set aside to make the wreath hanger by pinning the ends to the back of the wreath. Loop your ribbon through your wreath and hang it over your door, or window, making sure that the edge of the ribbon lines up with the top of the door at the opposite hanging side (see photo below!) using two, or i prefer three tacks, start by placing the first tack in the middle of the ribbon and pushing it into the door. Use hot glue to adhere strips to the form.
The fall colors of yellow, brown and orange have a timeless appeal.
Watch tutorial to best gauge how much ribbon you may need. Randomly push each pin and ribbon loop into the wreath form until the top and about 1/2 way down the outside of the wreath is covered. Yarn wreath yarn + laced ribbon + pins + burlap + fabric Add a bow to the upper portion and loop a ribbon through the center to use to as a hanger.