Is My Safety Switch On Or Off. Lift the float arm on the float switch while the system is running and hold it for at least 1 minute. My safety switch tripped approximately every 4 hours since 2pm yesterday.
Some systems have an internal time delay on the blower and will continue to run for 30 seconds to 60 seconds after receiving a low voltage signal to turn off. I have to get up @2:30 am this morning to turn it back on! I removed the adjuster bolt and then the other bolt holding it in place.
I suggest you to follow the below steps and check if it helps you regarding the family safety settings.
Using the safety switch to force i/o board firmware update¶ if the safety switch is held down for the first few seconds after a pixhawk is powered up, the i/o firmware is reloaded. The safety switch is made of the plastic harness. One set completes a circuit between two of the blades and. I have to get up @2:30 am this morning to turn it back on!